CWS Impact Garage Doors Nationwide | Winslow Windows & Doors

CWS Impact Garage Doors: The Fort Lauderdale Owner’s Guide

If your CWS impact garage door has a failed spring, bent track, or tired opener, we stock CWS-compatible parts and install them across Fort Lauderdale. Most repairs run $220-$480 for springs, $350-$750 for full door section replacement, and $1,450-$2,600 for a complete new CWS impact-rated door installed. We keep common CWS springs, cables, rollers, and hinges on our trucks, so we can usually get you squared away same-day. Here’s the pattern we see: a homeowner hears a pop around 7 a.m. when opening the door for work, the door stays shut, and now the car’s stuck inside. That’s almost always a spring. It’s the most common CWS failure point in South Florida, and it’s never a fun discovery.

Call (904) 913-5886

Which CWS Models This Applies To

CWS manufactures several impact-rated garage door lines, and Fort Lauderdale homeowners most often have the CWS WindSecure, WindGuard, or the older Miami-Dade NOA-approved series. The quickest way to identify your model is to check the sticker on the door’s inside edge near the bottom panel, or the label on the spring assembly bracket itself. That label lists the model number, date of manufacture, and the door’s wind-load rating. Here’s the gotcha worth knowing: CWS changed its spring torque specs on WindSecure models built after 2014. If you have a pre-2014 door and install a current-spec spring, the balance will feel slightly off, and the opener will work harder than it should. We match springs to your exact door build year, not just the model name. For most CWS doors, OEM parts are the right call because the galvanized coating and spring steel alloy are matched to Florida’s salt air. On non-safety-critical parts like rollers, a quality aftermarket equivalent works fine and knocks $15-$40 off the repair. We’ll give you that choice in plain terms before any work begins.

Note: Winslow Windows & Doors is an independent installer and repair provider. We’re not affiliated with CWS, but we’ve installed and serviced their products for years across Broward County and are an authorized installer of CWS doors.

Signs Your CWS Impact Garage Doors Is Failing

• Loud pop followed by a door that won’t lift. That’s a broken torsion spring. The pop is the sound of stored tension releasing, and the door now weighs full-frame with no counterbalance helping. Do not try to force it open with the opener.
• Door opens unevenly or jerks halfway up. One cable may have jumped a drum or frayed at the bottom bracket.
• Visible rust staining around the bottom panel corners. In Fort Lauderdale’s humidity and salt air, that’s typically the bottom seal track or the hinge brackets starting to corrode. Catching this early usually prevents a full bottom section replacement later.
• Crunching or grinding during operation. Worn rollers. Nylon rollers on impact-rated doors take a beating from wind load, and once the bearing gives out, the metal stem grinds against the track.
• Small gaps of light along the door edges when closed. Weatherstripping failure or slight track misalignment. On an impact-rated door, a gap is more than a draft; it can allow wind pressure to work against the door during a storm.

Replacement Cost & What’s Included

Here’s what you’re looking at for CWS impact garage door work in Fort Lauderdale:

• Torsion spring replacement: $220-$480 installed, depending on single or double spring setup and door weight.
• Extension spring system: $180-$320 for older CWS models still on extension springs.
• Cable replacement: $150-$250 per side, including drum realignment.
• Roller set (all rollers): $140-$220 for nylon rollers, including track lube and adjustment.
• Bottom weatherseal replacement: $95-$175, depending on door width and seal type.
• Full CWS impact-rated door replacement: $1,450-$2,600 installed for standard single-car sizes; double-car and custom wind-load requirements push higher.

The main cost drivers are door spring torque specs, wind-load rating, and whether your door opening is square or needs track adjustment. Every quote we give is a written, line-item price before we start, and it doesn’t change unless you ask us to add work. Repairs carry our workmanship warranty, and parts carry the manufacturer’s warranty, which we handle for you if anything fails.

DIY or Call Us?

Here’s the honest split. You can inspect the door yourself: look at spring condition, check for rust on cables, open and close the door a few times. If you see a problem, that’s enough information to describe it over the phone. What you should not do is touch the torsion spring. That spring is wound under enough tension to cause serious injury if it lets go while you’re adjusting it. Even a cable replacement can turn dangerous if the old spring still holds load. These are the jobs where doing it wrong costs you a lot more than the repair would have. If your CWS door is acting up, call us at (904) 913-5886. We’ll describe what we think is going on, quote you a price, and schedule the visit. No pressure, no scare tactics, just accurate information and a fixed price.

FAQs