Mr-Glass Door Installation Nationwide | Winslow Windows & Doors

Mr-Glass Door Installation: The Fort Lauderdale Owner’s Guide

Mr-Glass door installation in Fort Lauderdale typically runs $450 to $1,100 installed, depending on whether you need a full frame replacement or just new hardware and weatherstripping on an existing slab. We stock Mr-Glass-compatible door components on our trucks and can usually complete the job the same day we diagnose it. Most owners discover the problem the same way: the door starts dragging against the threshold, the lock no longer catches cleanly, or daylight becomes visible around the edges where it didn’t used to be.

Call (904) 913-5886

Salt air off the Atlantic and Fort Lauderdale’s brutal summer humidity work on door installations year-round. Hinges corrode, weatherstripping compresses, and aluminum frames that held square for fifteen years start to flex. Winslow Windows & Doors is an independent installer and service provider, not affiliated with Mr-Glass directly, but we’ve installed and repaired enough of their doors across Broward County to know exactly what fails and how to fix it the right way the first time.

Which Mr-Glass Models This Applies To

We service Mr-Glass impact-rated entry doors, French door systems, and sliding door configurations that were common in Fort Lauderdale homes built or renovated between roughly 2005 and 2020. Mr-Glass door frames run two standard widths in this market: 36 inches for single entry doors and 72 inches for paired French doors, both typically 80 inches tall. If you’re not sure what you have, check the hinge side of the door slab or the top rail of the frame for a silver label with the Mr-Glass model number printed on it.

One compatibility gotcha we see constantly: Mr-Glass door hinges are offset 3/16 inch further from the frame face than most off-the-shelf replacements. Homeowners who buy generic hinges from a big box store discover the door won’t close flush no matter how they adjust it. We carry the correct OEM-spec hardware, and for rollers and tracks on Mr-Glass sliders we prefer genuine Mr-Glass components over aftermarket equivalents because the bearing tolerances on the rollers are tighter than generic parts, and a sloppy roller eats the track within two seasons.

Signs Your Mr-Glass Door Installation Is Failing

• Door drags or scrapes on the threshold. This usually means the hinge screws have stripped out of the frame or the frame itself has settled. Florida’s wet-dry soil cycles shift slabs by fractions of an inch, and over a decade that’s enough to misalign a door that once swung perfectly.
• Lock bolt won’t fully throw or sticks halfway. Corrosion builds inside the lock body, especially on homes within a mile of the Intracoastal or the beach. The salt haze gets into everything, and a lock that fights you is a lock that will eventually lock you out.
• Visible gap at the top or latch-side corner. Weatherstripping has compressed or the frame screws are no longer holding. You’ll feel the draft and, more importantly, see the increase in your AC bill during August.
• Condensation or fog inside the glass insert. The insulated glass unit seal has failed. On Mr-Glass doors with decorative glass, this is not a repair, it’s a glass replacement, and it’s the single most common call we get on these doors in Fort Lauderdale.
• Door sounds hollow or rattles when closed. The door slab itself is fine, but the strike plate has loosened or the frame shims have compressed. It’s a quick fix if caught early; ignored, the rattling gets worse and the slab starts wearing the hinges asymmetrically.

Replacement Cost & What’s Included

In Fort Lauderdale, Mr-Glass door installation pricing breaks down like this:

• Hardware replacement (hinges, rollers, strike plates, handleset): $180 to $450 installed, depending on finish and part count
• Weatherstripping and threshold replacement: $150 to $350 installed
• Full door slab replacement with existing frame: $650 to $1,100 installed for standard Mr-Glass sizes
• Frame and slab replacement (full install): $1,000 to $2,400 installed, depending on frame damage and whether stucco repair is needed

Every quote is a written, line-item price before we start. That means the number on the estimate is the number on the invoice, no change orders and no “while we were in there” surprises. Ed Winslow’s name is on the door, literally, and that means it gets done right. Every job is also backed by Winslow’s 36500-Day Done Right Promise: if it’s not done right, we make it right.

DIY or Call Us?

You can safely check two things yourself: whether the hinge screws have simply backed out (tighten them with a screwdriver, and if they spin without biting, the screw holes are stripped), and whether weatherstripping has pulled loose from the frame channel. Both are diagnostic, not fixes, and knowing them helps you talk to us accurately when you call.

Where DIY goes wrong on Mr-Glass doors is the frame. A misaligned impact-rated frame under load can bind catastrophically, and if the slab is held in place with a broken hinge, the whole door can shift without warning. Impact-rated doors in South Florida are heavy, often 150 pounds or more for a single slab. That is not a two-person hobby project. If the frame is involved, the springs, the sag, the glass, call (904) 913-5886 and let us look at it. The estimate is free.

FAQs